Marathon MAGNUM ROUTER Guide de l'utilisateur télécharger pdf (Page 146)

Chapter 9: Sample Configurations

___________________________________________________________________

9-41

The only additional information needed is to program the route for the remote network into

Magnum B’s WAN IP Route Map table as shown below:

On Magnum A, RIP routing needs to be enabled. To do this, click on the WAN Config button,

then select the WAN IP Route Map button and finally the Advanced Routing button. The

following screen will be displayed:

In the upper right hand corner of this screen is a box to enable or disable RIP Version 1 routing.

Click on the box to add or remove the check mark signifying that RIP is enabled or disabled and

then click on Sav

e followed by Exit.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 166 167

Pas de commentaire

Marathon MAGNUM ROUTER Guide de l'utilisateur Page 146